Nantong Kingwell Machinery
News
Add:No. 19, Haifang Avenue, Xichang Development Zone, Hai'an City, Jiangsu Province
Tel:+86-513-88349588,88349589
Fax:+86-513-88349589
Contacts:Manager Hang
Phone:+86-18068965999
Email:kwx@kwxjc.com
Website:www.catbrewing.com
News
Home > News > News
At present, the selection machine for sheet metal processing of sheet metal, especially large sheet metal
Release time:2016-4-5
1. Operation process

A. The operator must be familiar with the general structure and performance of the bending machine equipment, and it is forbidden to use the equipment with super performance

B. The operator must master the "three good" and "four good" of the equipment used and use and maintain the equipment according to the "four requirements" of equipment maintenance

C. Before starting, add grease according to the equipment lubrication regulations, check the oil quantity and quality of the oil cup, and cover the oil cup hole

D. Before work, the upper and lower blades should be aligned first, and the blade clearance should be determined according to the thickness of the shear steel plate, which is generally between 5 and 7% of the thickness of the sheet to be cut. Each clearance adjustment should be made by manually flicking the flywheel to make the upper and lower blades move back and forth once, and check whether the clearance is appropriate with a feeler gauge

E. Loosen the bolts of the positioning retaining frame according to the requirements of the shearing workpiece, adjust the size and position of the positioning retaining plate, and strengthen it. Before operation, it is necessary to conduct a test run for 2~3 times to confirm that the lubrication is good and the operation is normal before operation

F. It is forbidden to loosen and tighten the retaining device or adjust the blade gap by knocking. When adjusting the guide rail clearance and blade clearance, stop the machine. It is forbidden to enter the shear zone by hand or pick up materials by hand during operation

G. The blade edge must be kept sharp. In case of damage, wear or dullness, it should be sharpened or replaced in time

H. When cutting plates of different thickness and different materials, the pressure of the pressing plate spring and the clearance of the blade should be adjusted properly to prevent the spring from breaking or damaging the blade edge

I. It is prohibited to cut the bar and place other items on the workbench to avoid entering the cutting edge and damaging the blade

J. It is forbidden for the operator to leave or entrust someone to take charge of the running equipment

K. Always pay attention to the clamping mechanism, clutch and brake for abnormal failure; The bending machine should concentrate on cutting. If any abnormality is found in the equipment, it should immediately stop cutting and cut off the power supply.

Notify relevant personnel for maintenance

L. After work, cut off the power supply, clean the equipment and make spot check records before leaving work

2. Safe operation procedures

A. It is forbidden to cut oversized and oversized materials, and it is forbidden to cut quenched high-speed steel, tool steel and cast iron

Before starting the machine, the clutch should be disengaged and the motor should not be started with load

C. Before starting the machine, test the cutting with empty car first, and then the machine can be processed after the test with empty car is normal

D. It is forbidden to cut explosive articles, bars, too thin workpieces and non-metals

E. Pay attention to whether the pull rod is out of order, whether the fastening screw is firm, and whether the fingers cannot enter the knife edge when feeding. It is forbidden for two people to cut two pieces at the same time on the same machine, and no one is allowed to stand behind the cutting machine

Hydraulic bending machine can be divided into torsion shaft synchronization, mechanical-hydraulic synchronization and electrohydraulic synchronization according to the synchronization mode

According to the mode of movement, hydraulic pressure can be divided into: up-acting type and down-acting type

Copyright ? Nantong Kingwell Machinery Co., Ltd  

  • Design by:HUOSU